Two-Shot molds manufacture-Taizhou mon mould factory:
How to creat a plastic part with 2 kinds plastic?There are 2 ways to moulded.
A:By over moulding method.
B:By 2-shot mold run on 2-shot injection machine.
Over moulding method:
Advantage:
1.Cheapest way to create mouldings with 2 kinds plastic.
2.Mould cheap,general injection machine is ok.
Defect:
Not safe.Over moulding flow as below:crate 1 kinds plastic part first,
Then put the plastic part inside of mould cavity,then injection again.So it is dangrous during
put parts inside of mould cavity.
Two-shot molds:
Advantage:
1.Safe to create plastic parts with 2 kinds plastic.No need put plastic parts inside of mould cavity during moulding processing.You can check our 2-shot mould tesing video on our youtube.com.
2.Moulding surface seemed beautiful,much perfectly than over moulding.
Defect:
High cost,as plastic parts moulded by 2-shot mold run on 2-shot injection machine.
Two-shot molds contains 2 kinds:
A:Rotate 2-shot molds.1 set molds contains 2 molds.This is popular type.
B:Non-rotate 2-shot molds.1 sset mold contains 1 mold,run on special 2-shot machine.
If you need 2-shot molds,Please inform us.
Best regards
Steven
Skype:monmouldsteve
E-mail:info@monmould.com/monmould@yahoo.com
web:www.monmould.com